The table top bracket fits into the groove cut into the skirt. When it is screwed into the table top hold it securely. We will be using metal corner brackets. Click here for instructions.

This is the table top bracket. Using this hardware can allow the tabletop to expand and contract slightly without damaging the table.

The left side is the edge that will fit into the groove in the skirt. Note that the horizontal parts are not parallel. When the groove is cut at the proper height, the inside of the bracket will be elevated.

With the groove at the proper height, tightening the screw into the tabletop will create downward pressure on the skirt.

After marking the proper height for the groove, cut it on the table saw.

After centering the skirt-leg assembly on the table top, position the table top brackets approximately 6 inches apart. Double check that the screws will not go through the table top, and attach the brackets.