Osborne Builder's Studio: DIY Table/Buffet Riser Using Crown Moulding
In this video we show you how to build a DIY Table Riser/Buffet Riser using crown moulding from Osborne. This is a great project for the holiday season as it can add some extra functionality to your dining table or buffet! The removable top allows you to customize the look of your piece depending on the occasion. For more information on the products used in this build and the videos mentioned, check out the links below!
Materials Used:
- Petite Detailed Crown Moulding (Part #892244)
- Table Levelers with Nylon Bottom (Part #935)
- Threaded Inserts - set of 4 (Part #4815)
- 1" x 2" Poplar Lumber
- 1/2" Plywood
- Decorative Hobby Fabric
Assembly Instructions
Overall Dimensions: 36” x 12” x 3 ½”
What we used:
|
|
|
|
|
|
Tools:
Miter Saw | Table Saw | Drill/Drill Press | ½” Drill Bit | Tape Measure | Allen Key |
|---|---|---|---|---|---|
Wood Glue | Brad Nailer/Nails | Scissors | Spray Adhesive | Stapler | Writing Utensil |
Cut List:
Crown Moulding | 1” x 2” Framing | Removable Top |
Instructions:
Step 1
First, you need to cut a 45 degree bevel on one end of the moulding stick.
Step 2
Measure out 36” before making the next cut.
Step 3
Once the moulding is cut to length, you can start creating the interior frame from the 1x2 lumber. Once the interior framing is cut, make sure the mitered edges line up properly before installing onto the back of each piece of crown moulding. Install the framing flush with the angle on the back side of the moulding. This will give us about a ½ groove that will accept the floating top.
Step 4
To attach the frame, use some wood glue and a bad nailer. Add wood glue to each corner and use a small brad nail to keep everything secure while drying. It is important to make sure that the miter and bevel cuts line up during this step.
Step 5
Add nylon table levelers to the bottom of the riser. We used the threaded inserts and mounting blocks that were cut from scrap wood. Mark the location for both the blocks and inserts before installing. Then, use a drill press to create pilot holes that are slightly smaller than the threaded insert (we used a ½” drill bit).
Step 6
Before installing the threaded insert, secure the mounting blocks to the frame using wood screws. Avoid the crown moulding. To install, start inserting by hand and then use a proper size Allen key to slowly countersink the insert in the wood.
Step 7
Once the insert is installed, test the fit of the table leveler and attach. Repeat the process for the other three corners.
Step 8
Take the measurements of the removable top to cut fabric for covering. Leave an ⅛” extra on each side when measuring. The top is made from ¾” plywood which will have a slight reveal but a thinner plywood can be used if desired.
Step 9
Place the plywood on the back side of the fabric and cut the fabric accordingly. To attach, use a quick set spray adhesive. Spray a coat on both the fabric and the plywood and let those sit for a minute before attaching.
Step 10
Once the fabric is installed, test the fit of the removable top in your riser frame. If all is good, apply the finish of your choice to the riser.
